Order quality Tool Holders,
Collets and Feeding Fingers from National Distribution-
an Authorized B&S distributor.
|
 |
Accurate- Easy to Adjust! Correct
Misalignment Between Spindle and Turret! Adjustable Holders are used for holding drills, reamers, counterbores and similar tools, providing a simple means of centering these cutting tools with the work. |
|
The cutting tool is mounted in the head of the tool either directly or by use of a bushing and is clamped securely in place by a set screw. An important advantage of this holder is that it maintains the axis of the tool parallel with the machine spindle, an essential condition for accurate alignment of the tool with the work. No.67 Floating Adjustable Reamer Holders |
 |
Self-Aligning -Reams To Size- Eliminates Chatter-Eliminates Bellmouth! The Floating Reamer Holder has outstanding Operational advantages. As its name suggests, the holder floats freely on bearings, providing alignment when the reamer enters the hole. The Floating Holder and the reamer are held centrally by a neoprene ring. |
|
The reamer, after being adjusted to approximate alignment with work, aligns itself with the hole being reamed, eliminating bellmouth and egg-shaped holes. No.185 Adjustable Knurl Holders |
 |
Increase Capacities with Greater
Rigidity! These Knurl Holders have a bushing arrangement which facilitates the rapid adjustment or replacement of knurls. Loosening two screws allows the bushing, the adjusting screw, and the swivel to be adjusted or removed as a unit. Under actual production conditions, set-up time has been reduced as much as 50%. |
|
These holders have ruggedness and rigidity and use full machine capacities. Carbide Knurl Pins are provided for long life. Knurl not furnished. Tool Posts For Circular Tools |
 |
Hold
Circular Forming Tools on Cross Slides
All Circular tool posts have fine adjustments for setting tools accurately on center. Each tool post is equipped with a raising block so it may be used with the spindle running on either direction. A swivel is also provided for squaring-up the tool post. |
|
Adjustable V-Jaw Tool Holders |
 |
With Reversible Clamp for Extended Tool Holding Range! Eliminate Bushings-Center Tools Accurately! |
| Any size tool within the range of these
holders will be held securely-whether the size is a
fraction or a decimal, letter or number, English or
Metric. One V-Jaw tool holder will hold them all. Bushings are not needed with the Adjustable V-Jaw Tool Holder. Save the costs of inventorying them or making them-save the time and annoyance of finding the right one. The V-Jaw Tool Holder centers tools accurately and gives you the precision capabilities of a Toolmaker's V-Block. The "V" is square to the face within .0003"; the face is square to the shank within .0002". The reversible clamping piece completes the steadfast 3-line grip- with no marring of the tool. Shank and flange are one piece, for extra rigidity. Simple centering (especially since one wrench fits all screws.)
|
|
